Echo Audio AUDIOFIRE 12 Manuel du propriétaire télécharger pdf (Page 27)

Console Software

all times, whereas the input monitor controls (pan, solo, mute, faders and gang)

that you see will change depending on which output bus is currently selected.

The input monitor controls are a little complicated. Basically, there is

a different

set of input monitor controls for each output bus, but only one set is visible and

changeable at a time. In the example above, the only set of input monitor controls

that is visible and changeable is the one for the output bus called “Analog 1-2". To

see and change a different set of input monitor controls you will need to select a

different output bus (see the “Bus Select” section above).

The level meters do not change when a different output bus is selected. They

always reflect the signal level being received on the inputs. In the example above

you can see that the signal level on the ANALOG Out 1-2 meters is less than that

on the input meters. This is because the ANALOG 1-2 faders have been adjusted to

–6, thereby decreasing the amount of the input signal that is being sent to analog

outputs 1-2. If the Analog 3-4 tab is selected the console would appear as in the

example below.

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 59 60

Pas de commentaire

Echo Audio AUDIOFIRE 12 Manuel du propriétaire Page 27