Echo Audio Mona Manuel du propriétaire Page 29

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 83
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 28
29
For this reason, Mona supports many synchronization modes. Mona can
slave to word clock, S/PDIF, and ADAT. In addition, Mona can also
generate these synchronization signals and Esync, as well as perform
translation of one clock to another, such as transmitting word clock while
reading ADAT.
Lets take a brief look at the various synchronization types.
Word Clock This is a synchronization signal that connects to the BNC
connector labeled Word Clock on Monas back panel. This synchronization
clock runs at the selected sample rate. Think of it as a kind of electronic
metronome, which clicks back and forth at the digital sample rate. It is one
of the most widely used forms of synchronization in digital audio. Mona is
always generating Word Clock on its Word Clock output BNC connector.
S/PDIF The Sony/Phillips Digital Interchange Format is a serial bit-
stream that has a clock signal embedded in the data stream. When recording
from an S/PDIF source, whether via optical or RCA cables, Mona will
utilize the synchronization clock that is embedded in the S/PDIF while it
decodes the bitstream.
Note:
When recording from a S/PDIF port, you must select S/PDIF as the
input clock. For greater flexibility, this is not done automatically. If you
find that your S/PDIF recordings contain pops or skips, be sure that you
have selected S/PDIF as your input clock.
ADAT The Alesis ADAT optical interface can send and receive up to 8
simultaneous channels of digital audio data over fiber optic cables. Unlike
wire cables, fiber optic cables do not add noise or interference. To check if
the optical cable is carrying a signal, just look at the end for a glowing red
light. Mona can send out (or master) ADAT clock as well slave to it. If
you want Mona to slave to an ADAT clock, just set Monas input clock to
the ADAT setting.
Note:
To preserve the high audio quality of Monas converters it is best to
use Monas Internal input clock setting instead of synchronizing to an
external ADAT clock, which may add unwanted jitter to the signal.
Vue de la page 28
1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 82 83

Commentaires sur ces manuels

Pas de commentaire